Instructions
-
Setup
-
1
Place the litter box close to an electric socket, preferably where you used to put the old litter box.
-
2
Cut the restraints on both ends of the rake, pull them out and throw them away.
-
3
Remove the protective tapes on the cover of the waste receptacle compartment and the battery compartment. Take off the Styrofoam lying on the rake.
-
4
Fit a disposable waste receptacle under the waste receptacle compartment cover. It should attach tightly under the five tabs on the litter box.
-
5
Put the waste receptacle lid on the disposable waste receptacle by fitting the push tabs into the round holes.
-
6
Remove the paper strip on the carbon filter and stick the side with the adhesive onto the diamond-shaped insert in the waste receptacle lid.
-
7
Close the waste receptacle compartment.
-
8
Fill the litter box with premium clumping litter until it almost reaches the "full line."
-
9
Plug one end of the AC adapter into the LitterMaid LM500 and the other end into an electric socket.
-
10
Turn on the LitterMaid LM500. You will see a red light turning on at the top of the litter box and the rake tidying up the litter.
Litter Change
-
11
Push the two round tabs on the waste receptacle compartment cover, remove the cover, take out the waste receptacle and throw it away.
-
12
Turn off LitterMaid LM500 and unplug the cable.
-
13
Remove the litter tray by lifting the side latches and the side panel handles.
-
14
Throw away used litter.
-
15
Dip a piece of cloth in water and use it to wipe the litter tray.
-
16
Spray non-stick cooking spray or silicone spray on the litter tray surface to prevent waste from sticking to the litter tray. Remove excess spray by wiping it off with a dry cloth.
-
17
Replace the litter tray in the main housing by pressing it into place until you hear a clicking sound.
-
18
Fill the litter tray with litter and turn on LitterMaid LM500.
-
1