Things You'll Need
- Tape measure
- Scissors
- Thick memory foam or egg carton foam
- Fabric
- Plastic sheeting
- Non-toxic glue that is washable when dry
- Non-toxic fabric glue
- Hook and loop closures
- Sewing machine and thread (optional)
- Twin mattress waterproof cover (optional)
- Waterproof pillow cover (optional)
- Insert for heat or cold therapy (optional)
Instructions
Measure your dog to determine the size bed you need. With the dog lying down or standing still, measure from the tip of its nose to the base of the tail. It may be easier to break this into two measurements--nose to shoulders, shoulders to base of the tail--and add the two for the full length measurement. Then measure your dog from the bottom of the front paws to the top of the head. Add at least 5 to 7 inches to both measurements for stretching room.
Cut the foam to the length and width you calculated in Step 1. If your foam is thinner, you can put two layers together to make it thicker. To keep the layers from shifting and sliding apart, bind the pieces together by gluing them or using strips of loop and hook fasteners.
Cut the fabric and the plastic sheeting larger than the foam. Since the thickness of the foam can vary, a good way to measure the fabric and plastic is to wrap them over the foam and mark the length to cut them, allowing for seams and the closure of the outer cover. The length of the fabric, as well as the plastic, should be the length of the foam plus the thickness of the foam plus about two inches. Add the thickness of the foam plus two inches for the width of the fabric and sheeting also. Remember to cut a front and back piece of the fabric and the plastic.
Place the front and back sheets of plastic together, making sure all edges meet properly. Glue the edges together on three sides. Place the foam inside the plastic case you just made, and glue the edges of the final side together.
Place the front and back pieces of fabric together, dull side out. Sew or glue the edges on three sides.
Sew or glue a loop fastener strip to the front side edge, and a hook fastener strip to the back side edge. Turn the fabric case right side out.
Insert the plastic covered foam into the case you just made and press the hook and loop fasteners together.