Instructions
Connect both the collar and the receiver to their respective charging units by plugging in the cord from the charger into the port at the bottom of each device. Allow both items to charge for a full 24-hour period the first time you use it and for 12 hours each time afterward.
Remove both items from their chargers. Press and hold the "Activation" button on the receiver for one second and you will see a red LED light turn on and hear a beep. Release the button and the light will begin to blink while the unit is in use.
Wash your dog's neck with shampoo and water before placing the collar on his neck. Place the collar over the neck so that the receiver is centered on the underside of the neck. Pull the collar through the buckle and secure it so that there is enough room for you to place one finger between the collar and your dog's skin.
Turn the switch on the receiver to the "M" position to give your dog momentary stimulation. This will give them a short snip to help them stop or slow down if they get too far away from you. Press the bottom button on the receiver to give a low stimulation, and the button above it for a stronger stimulation. You can also adjust the intensity knob on top of the receiver to raise or lower the strength.
Turn the switch on the receiver to the "C" position to give your dog constant stimulation. Use this if the dog is not responding properly to the momentary stimulation. In this mode, the dog will receive stimulation as long as you have one of the buttons pressed down.
How to Use Sportdog ST100P
The Sportdog ST100P is a receiver that is is part of the Sportdog Prohunter 2400 remote training system. By using this receiver along with the collar that comes with the system, you will be able to train your dog to stay close to you while out hunting, hiking or jogging. Once the receiver and collar are charged, you can then attach the collar to your dog. You can use the receiver to provide the stimulation to help train your dog.