Things You'll Need
- Shovel
- Chain link fencing
- Hammer
- Posts
- Measuring tape
- Tent stakes
- Gate
- Timber
- Nails
Instructions
Building a Dog Run
Identify where the dog run is to be built. Make sure the area is flat and provides enough space for the dog to wander around in. Remember that the size of the run should reflect the size of your dog. A large dog will require a much bigger run than a smaller breed.
Measure the area with a measuring tape and identify where you will position the posts. The larger the run, the more posts and chain link fencing you will require.
Dig holes where the posts are to be placed. For a 5 foot high fence, use posts that are 7 feet high and place them in holes that are 2 feet deep. Make sure the posts are spread out equally. Try placing three posts 10 yards apart on each side, with 10 yards between them. Place a further post at either end in the middle to seal the run. Place all the posts into the holes and fill with cement mix. Allow it to set overnight. To fix the gate, place two posts the width of the gate apart and hang. It should be around 2 inches off of the ground. The gate will need to be braced to prevent it from sagging over time. A simple Z brace will be adequate. Lay a piece of timber diagonally from corner to corner on the gate and fix down with nails.
Tie chain link fencing between the posts. This will prevent the dog from escaping and is sturdy enough for all breeds. Tie the fencing to the ground with tent hooks for added security.
Place bricks along the perimeter of the dog run to cover any exposed wire and to prevent the dog from digging under the run.