How to Repair a Tracking Collar

Dog tracking collars are often used by hunters who have hunting dogs that follow game. The collar can be located via the satellite that matches the unit. This aids in finding lost or wandering dogs in thick forests or mountainous terrains. While these collars are very useful when it comes to tracking dogs, they sometimes may become defective and need to undergo simple repair.

Things You'll Need

  • Tracking collar
  • Collar responder
  • Batteries
  • Screwdriver
  • Isopropyl rubbing alcohol
  • Clean cloth
Show More

Instructions

    • 1

      Remove the cap from the transmitter off the collar and clean the contact points. These are the connections that power the transmitter. Put a dab of isopropyl rubbing alcohol on a clean cloth and rub some of the alcohol onto the contact points. This helps to remove any dirt or grime that may have collected on the contact points over time. Wash your hands thoroughly to remove any alcohol that touched skin. If this does not fix the problem, the end caps may need replacing.

    • 2

      Place the removed end cap to the side and replace it with a new cap from another collar. If another collar is not available, you may need to purchase one from the manufacturer. Ensure the cap is securely attached and the points are making a proper connection. A new cap should fix the poor connection. If the transmitter functions, the removed end cap should be replaced. However, if the new end cap did not work, the batteries in the collar should be checked.

    • 3

      Disconnect the batteries from the tracking collar battery pack. Inspect the plastic located around the batteries for breakage or tearing. An improperly fastened plastic wrap around the batteries may cause them to drain when the collar is not in use. This will eventually reduce the life of the batteries if left unfixed. Place new batteries into the battery pack and turn the collar on. If the collar functions properly, the previous set of batteries were old. Dispose of the dead batteries and operate the collar regularly. If new batteries still do not help, make sure the frequency reading is correct.

    • 4

      Turn the tuning wheel until the broadcasting frequency on the collar is the same as the transmitter. If the frequency reading is incorrect, the two devices will not make a proper connection. Keep turning until the frequency that gives the highest readout is found. The transponder should make a clicking noise when the best frequency is discovered. If the collar still does not work, it may need to be replaced.