Things You'll Need
- Plastic Barrel
- Drill and ½" bit
- ½" O Ring
- ½" flat washer
- ½" Brass fitting
- Stainless steel nipple drinker
- Permanent Marker
Instructions
Mark the location for the first nipple on the plastic barrel. It should be approximately 4" or more from the ground.
Use the drill and ½" bit to drill a hole in the barrel.
Press a stainless steel nipple drinker through the hole. It may be necessary to twist nipple to get it to go through the barrel.
Place the O ring, flat washer and brass fitting on the threaded end of nipple drinker and tighten.
Repeat the procedure until you have installed as many nipples as desired.