Things You'll Need
- 55-gallon metal barrel cut in half for a scalding vat and a heating vat
- Hot water
- Thermometer
- Sharp scraper, razor or knife
Instructions
Bury the scalding barrel in the ground at a slight angle to make it easier to get the hog in and out of the hot water. If the angle is too flat, the barrel won't hold enough water to cover the hog.
Heat the water in the other barrel to about 140 to 145 degrees Fahrenheit. At this temperature, it will take three to six minutes of scalding to remove the scruff (the oil, dirt and outer layer of the skin) and loosen the hair. Winter hair is harder to remove and requires temperatures of 146 to 150 degrees.
When the water is nearly ready, kill and bleed the hog.
Place the hog head-first into the scalding barrel.
Rotate the hog in the barrel. Remove it from the water occasionally. Check the hair often to see if you can pull it out easily. The hair will first be ready on the sides and back of the hog, followed by the flanks.
When you can pull the hair easily from the flanks behind the shoulders, remove the hog.
Place hog's rear in the scalding water.
While the rear of the hog is scalding, insert the top of a hook into the toenails and dew claws of the front feet. Pull to remove the toenails and dew claws.
Use your scraper, knife or razor to scrape the head. Pay attention to the ears and snout.
When you can pull the hair from the rear flanks, remove the hog from the water.
Use the hook to pull the toe nails and dew claws from the rear legs.
Pull the hair from the tail and scrape the rear legs.
Scrape the feet and other difficult areas, then move to the easier back and sides of the hog.