Things You'll Need
- Sterile saline or clean water
- Sterile, non-stick 4-inch by 4-inch gauze pads
- Absorbent, rolled cotton -- usually 12-inch by 36-inch
- Non-stretch gauze -- 4-inch
- Non-elastic bandage tape -- 1-inch
- Elastic fabric wrap or elastic bandage tape -- 4-inch
Instructions
Applying the Bandage
Clean the wound with sterile saline to remove any dirt or hair if blood loss appears to be slowing down; use regular water if saline is not available.
Place a sterile, non-stick gauze pad over the wound. Do not administer any medication to the wound until the veterinarian has examined the horse.
Roll the absorbent padding, such as rolled cotton, around the leg starting from inside to outside--and then from front to back. On the right leg, you will be rolling in a clockwise direction; on the left, counter-clockwise. Make sure the padding is smooth and flat and--around 2 inches thick.
Lay the 4-inch gauze just above the hoof and begin wrapping in the same direction as the padding. Overlap each layer by half the width of the gauze as you work your way up the leg to prevent slippage. Fasten the end of the gauze to the top of the padding with non-elastic bandage tape.
Apply elastic fabric wrap or elastic bandage tape on top of the gauze just below the bottom of the padding and begin wrapping the leg in the same direction as your other wraps. Spiral the pressure wrap up the leg, again overlapping by half the width of the roll. Make sure to provide even tension all the way up, compressing the padding to control inflammation and bleeding.
Check the bandage to make sure it is not too tight. You need to be able to place one finger comfortably under the top and the bottom of the bandage without it moving around. This ensures it's tight enough to protect the wound, but not so tight as to cutt off circulation to the limb.