Things You'll Need
- Two 1" by 12" pieces of lumber, 33 " long
- Four 1" x 2 1/2" pieces of lumber, 28 long
- One 1" x 12 piece of lumber, 25 1/2" long
- Small diameter wood nails
- Hammer
- Saw
- Varnish or stain
- Paint brush
Instructions
Assembly
Saw one end of each of the 33" boards into a point with an angle of approximately 110 degrees. Each of the angled edges should be approximately 6 1/2" in length.
Nail the 25 1/2 inch board between the two 33" boards perpendicular to them. This board should be placed 5 1/2 inches from the ground.
Beginning 1" from the point of the upright 33" boards, nail two of the 1 by 2 1/2' boards on each side of the point. Leave approximatly 1" between them. There should also be a slight overhang on both the front and the back.
Sand until the boards are smooth.
Stain or varnish to taste.