Things You'll Need
- Bridle with a mild snaffle bit
- Saddle and girth
- Draw reins
Instructions
Tack up your horse in a saddle and bridle with a snaffle bit. Unbuckle the draw reins at the buckle in the middle.
Attach the end of the reins to the girth. Most draw reins are designed to loop around the girth. Position the loop ends between the horse's elbow and the bottom of the saddle flap.
Run the reins through the bit rings from the inside to the outside, below the snaffle rein. Re-buckle the rein in the center.
Hold the draw rein as you would a double bridle rein, with the draw reins on the inside, between your middle finger and ring fingers, and snaffle reins on the outside, between your ring finger and little fingers. Maintain more contact with the snaffle rein than the draw rein, using the draw rein only when needed.
Having a trainer on the ground when you are first learning to properly use draw reins is crucial. Warm your horse up well without the draw rein before introducing it to help avoid injury. When first introducing the draw rein, be attentive to signs of stress or panic, and release the draw rein immediately. Be sure to give plenty of forward aids with your legs and a soft seat to ride your horse into the contact.
Use draw reins as an occasional training aid, not as a constant crutch. After riding for five or 10 minutes with draw reins, try achieving the same feel without them. If another reminder is needed, use the draw reins for a few minutes before trying again without them. Allow your horse plenty of opportunities to stretch his head and neck down on a long rein, especially at the end of your ride.