A DIY Stand for the Biocube 29

Biocubes are cube-shaped aquariums. The Biocube 29 is a 29-gallon tank. Stands for the Biocube and other aquariums all require the same specifications. They must be strong enough to hold the aquarium. Other than strength and durability, these stands differ by their appearance and function. A very basic stand can be built out of standard construction lumber. It will not be a decorative stand, but it will serve the function of supporting the tank just as good as any other stand.

Things You'll Need

  • Tape measure
  • 2 pine boards, 2-inch by 4-inch by 21-inch
  • 2 pine boards, 2-inch by 4-inch by 17 1/8-inch
  • 4 pine boards, 4-inch by 4-inch by 17 inch
  • Plywood, 1/2-inch by 20 1/8-inch by 21-inch
  • Screw gun
  • 32 wood screws, 3-inch
Show More

Instructions

    • 1

      Set two 21-inch boards on edge, parallel and 17 1/8 inches apart. Set two 17 1/8-inch boards perpendicularly between them on edge and 18 inches apart. The corners should be flush. Screw through the 21-inch boards and into the ends of the 17 1/8-inch boards. Use eight screws for this task.

    • 2

      Position a 17-inch board inside each corner of the frame so they are perpendicular to the frame. These are the legs to your table. The ends of the boards should all be flush with one side of the frame. Screw four screws through each corner of the frame and into the legs.

    • 3

      Turn the Biocube stand upright and set your 21-inch plywood on top so all the edges are flush. Screw the plywood to the frame using eight screws.