Things You'll Need
- Two 5-gallon buckets One 5-gallon bucket lid Bio balls Sheet filter pad 1-inch bulkhead Drill Saw 3/16 drill bit 3/8 drill bit 1 1/4-inch hole saw
Instructions
Prepare the buckets. Take the first bucket and drill several holes in the bottom with the 3/8 bit to provide adequate drainage. You want to put as many holes as you can without making it so weak that it will not hold the filter media. For the second bucket, use your saw to remove the bottom 2 inches of the bucket. Do not discard since this 2 inches is what you want to keep.
Take the 2-inch bottom that was removed from the second bucket and repeat the drilling process as on the first bucket, this time using the 3/16 bit. This will serve as your trickle plate.
Using the hole saw, drill the top of the lid and install the bulkhead directly in the center of the bucket so that the output plumbing from the aquarium can be easily connected.
Fill the first bucket with your bio balls or whatever biological filtration you choose. I fill up about 6 to 8 inches with media. On top of this rests your filter mat, and then in goes the trickle plate made from the bottom of the second bucket.
Replace the lid and connect the plumbing.