Things You'll Need
- Rectangular foam block
- Rubber tubing
- Electric water pump
- Litter pan
- Screwdriver
Instructions
Twist the screwdriver up through the bottom of the foam block, creating a tunnel running vertically through it.
Again with the screwdriver, make a horizontal tunnel near the top of the block that intersects with the vertical tunnel at a 90-degree angle. The hole you created near the top of the block will be the location from which water spouts.
Run the rubber tubing up through the vertical tunnel in the foam block, leaving a few inches protruding from the bottom.
Connect the end of the exposed rubber tubing to the output of the electric water pump. The output is where the water spouts from the pump after it has been sucked in.
Fill the litter pan with water and place it within the enclosure.
Place the waterfall mechanism, along with water pump, into the litter pan and plug the pump's power chord into an outlet. Water should begin flowing through the rubber tube and out of the top of the foam block.